UHP-100 HIGH-THROUGHPUT SATELLITE ROUTER
GENERAL DESCRIPTION AND INSTALLATION GUIDE, v3.2
© UHP NETWORKS INC 2016
9
www.uhp.net
1.5.1
Overview
Each module of UHP-100 satellite router has its own interface to external devices. All the interfaces are
located on the rear panel of the device. The indicators are located on the front panel. LAN Indicators are
integrated into the LAN connectors on the back of the router.
1.5.2
Router composition
UHP-100 router consists of:
1.
IF switch with two inputs
2.
Two high-speed DVB demodulator
3.
Universal modulator
4.
IP Router
5.
Ethernet switch with two Fast Ethernet interfaces
6.
USB console
7.
Power supply
Figure 5 UHP-100 router – rear view
1.5.3
Power connector (DC 24V)
UHP-100 router is powered with 24 VDC. AC Power supply adaptor is supplied with the set. The router can be
powered from a DC power source (batteries, DC-DC converter), but the specific power supply mode should be
agreed upon with the Manufacturer. Power supply connector features dimensions 5.5 / 2.1 mm (outer and inner
diameters). Positive terminal of the source is on the central contact.
1.5.4
LAN interface connectors (LAN1 and LAN2)
LAN connectors are purposed for connecting of the CPE or for cascading of several routers. Bit rate 10 or 100 Mbps
are supported. Indicators built into the connector mean the following: green – connection (Link) and data
transmission (Activity), yellow – activation of half-duplex mode.
1.5.5
USB CONSOLE
The console port provides local control of the device. A standard miniUSB cable is required to connect to the
router (not supplied).
1.5.6
Modulator output (TX OUT)
TX
OUT
OUTPUT CAN FEATURE
24
VDC
WITH A HIGH SHORT
-
CIRCUIT CURRENT
.
S
HORT CIRCUITING CAN CAUSE
SPARKLE SPREAD AND BURNS
.
T
HIS VOLTAGE CAN DAMAGE MEASUREMENT EQUIPMENT IF IT IS NOT PROTECTED AT ITS
INPUTS
.
S
UPPLYING EXTERNAL VOLTAGE TO THIS CONNECTOR IS OBJECTIONABLE AND SUPPLYING MORE THAN
24
V
IS
PROHIBITED
.
UHP-100 modulator is compatible with most satellite transmitters/converters (BUC). Those incompatible are only
transmitters that require to explicit “TX On” FSK command but such transmitters are extremely rare and are not
widely employed.