uhlmann & zacher CX8946, Инструкция по эксплуатации и сборке для клиента

Страница: 12 / 23

CX8946 C
ONNECTION AND INSTALLATION
11
4.4 Installation

Specify the installation position. Ensure that the surface is smooth, dry and
firm enough. Do not place the units close to each other, to avoid radio
interferences.

Unscrew and remove the housing cover.

Mark the fastening points through the bottom of the housing.

If required, drill mounting holes into the mounting surface.
Hand-tighten the lower part of the device at the planned location using suitable
flat-head screws. Installation material is not included in the scope of delivery. In
case of cable feeding from the side, use additional fitting rubber or plastic
spacers, if necessary. Ensure that the cable is not pinched.

Perform commissioning (see the "Commissioning" chapter).

Put on the housing cover and screw it tight.