C
LEX
E
LECTRONIC DOOR HANDLE
A
SSEMBLY
3
1
Assembly
This document does only cover the assembly in combination with the adapter
plate for Scandinavian doors. It does not replace the regular operating and
assembly manual. Please consult the regular operating manual for all other
product related questions.
1.1
General assembly instructions
CAUTION
The cover of the electronic door handle can be damaged if
the mounting screws are too long!
Tighten the mounting screws with a torque of 2 Nm.
If a cylinder holder is present in the door, then it should be sealed properly,
for e.g. using a dummy cylinder.
Carry out the assembly with the door open.
Ensure that the latches or seals fitted to the door do not hinder the proper
operation of the product.
Ensure that the door handle does not protrude and prevent the door from
swinging freely.
The hole in the door for inserting the handle pin should have a diameter of at
least 25 mm.
Before assembling the door handle, always check whether all the components
can move freely.
After assembly, check the function with the door open.
The pre-tension in the mortise lock or the deviation of the horizontal basic
position must not exceed 3°. If the deviation is greater, the electronic lever
handle cannot engage and disengage
