Ugur USS 100 DSCL, Руководство по эксплуатации

Страница: 28 / 115

EN EN
E- CLEANING, MAINTENANCE AND TRANSPORTATION OF YOUR
COOLER
D- USING YOUR COOLER
Shutting down your product
Defrost function
CLEANING
Internal cleaning
External cleaning
- Transfer the foodstuff inside your product to a convenient place.
- Unplug your product. (Picture 18)
If your product will not be used for a long time, apply following considerations;
- Clean your product. Otherwise the humidity on the wall may cause darkening of the internal surface.
Your product has automatic defrost function. Your show case will melt frost automatically when it is necessary to defrost
while running
Although your product automatically prevents frost deposit, frost deposit ratio may increase due to high temperature
and humidity as well as frequent use of the device. Running period increases as the frost deposit increases. That also
increases the energy consumption. In such cases, stop your product and ensure melting of the frost.
Cleaning of your device is composed of two stages, which are the internal cleaning and external cleaning.
Following warnings must certainly be abided before start cleaning.
Transfer the foodstuff inside your product to a convenient place.
Before the internal cleaning, wait until the temperatures of the internal parts of your product reaches to the ambient
temperature.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Remove the accessories from inside.
Perform cleaning with a soft cotton cloth and warm soapy water or by using the cleaning agents recommended by
Uğur Soğutma A.Ş.
Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
Make sure that no wet or humid area is left in the internal section after cleaning.
You can reload your product two (2) hours after running your product as stated in this manual.
Clean with a cotton cloth and warm soapy water.
Prevent penetration of cleaning water into the front control panel and lighting section while cleaning.
Clean the door gasket by using clean soapy water only.
DO NOT FORGET!
An evaporator without frost will always run with high efficiency
Water from the evaporator drops onto the drop tray at compressor section. Even though hot gas evaporates water
here, it will be better to check and clean once a month
SUGGESTION
You can use Uğur branded cleaning agents, which you can get from Authorized Uğur Services for internal
and external cleaning of your device.
CAUTION!
CAUTION!
If your product will be stored at an indoor place after shutdown;
• Do not cover it with plastic sheets. Plastic will cause smell and sweating of your product as it does not breat-
he. Corrosion may be seen as the result of sweating.
• Smell formation may occur in cases where you fail to store your product with the door open.
• Unplug your cooler before every cleaning.
• Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
• Never use abrasive and scratching substances (flammable and sparkling, solvent like gasoline, thinner, acid )
as cleaning agents. Never use flowing and pressurized water for cleaning.
Picture 18
54 55