UFREE SCOOTER www.scooter-manufacturer.com
6
ADJUSTMENTS AND OPERATION
REMOVEABLEPLATFORM
The Platform is removable to gain access to the Batteries. To remove,
remove the four deck screws with a Phillips screwdriver (fig 6) and remove
Brake Pedal and Spring. Platform will lift off of Scooter Frame. Reverse
procedure to replace platform.
CAREFULLY REMOVE SCREWS, SPRING AND
BRAKE PEDAL TO GAIN BATTERY ACCESS.
FIG. 6
DRIVE BELT ADJUSTMENT
AND REPLACMENT
Periodic adjustment of the Drive
Belt is required. The Belt will
become loose after hours of
operation. When it does, the Belt
will make a popping noise while
accelerating. When this occurs,
you must tighten drive chain
immediately to tighten Belt,
loosen Rear Axle Nuts slightly
and rotate the Belt Adjuster
Discs equally Tighten Axle
Nuts and recheck belt tension.
If Belt is damaged or worn
please contact YOUR LOCAL
DISTRIBUTOR for a
replacement. Be sure to specify
Scooter. Remove rear wheel from
scooter to replace belt.
Reassemble, see Belt Alignment.
Drive Belt Alignment.
If
you
experience either the Drive Belt
coming off the Drive Gear or
Wheel Gear and/or rubbing
against the scooter frame, there
most likely is belt misalignment.
To realign carefully place the
upside down on a Sturdy surface
(table, stool, etc.) and determine
the direction of Belt side
movement. You will need to
move the Rear Wheel left or
right slightly to realign. To do
this loosen Axle Nuts slightly
and Rotate Belt Adjuster Discs.
Tighten Axle Nuts and Check
alignment by engaging power.
Recheck alignment after
riding-readjust if necessary.
