UFO NOVA DMX, Руководство пользователя

Страница: 4 / 16

Nova Illuminator Range
4
CONNECTIONS
There are 3 connections required – the fiber port, the mains supply cable and
the DMX control cable. The fiber port should be connected first. Connect and
secure the fiber optic connector into the green collar and secure using the M5
locking screw.
Connect the IEC power cord into the Desk Top PSU and plug the mains plug
into the electrical supply socket. Switch on power. The LED Indicator will
illuminate and the illuminator is ready for use. If no light is produced consult
the TROUBLESHOOTING section.
For DMX control connect up the DMX control cables to the XLR sockets on the
rear of the Illuminator. The pin out details for the plugs are shown below.
RJ45 CONNECTIONS
Note:
It is recommended that a 120ohm terminating resistor be
connected across DMX+ and DMX- on the last illuminator
on the DMX universe or cable run
Pin No 1 2 3 4 5 6 7 8
Color
White
Orange
Orange
White
Green
Blue
White
Blue
Green
White
Brown
Brown
Function
DMX+
(HOT)
DMX-
(COLD)
Spare Spare Spare Spare Ground Ground
DMX-XLR
equivalent
Pin 3 Pin 2 Pin 1 Pin 1