UFO Mercury MER3000 0-10V, Руководство пользователя

Страница: 6 / 16

Mercury Light Source Range
6
CONNECTION MER3000 0-10V
There are three connections required - the fibre port, the mains supply cable and the 0-10V
control cable. The fibre port should be connected first. Connect and secure the fibre optic
connector into the green collar and secure using the M5 locking screw.
Connect the IEC power cord into the Desk Top PSU and plug the mains plug into the
electrical supply socket. Switch on power the led Indicator will illuminate and the light
source is ready for use. If no light is produced consult the TROUBLESHOOTING section.
NOTE: THESE LIGHT SOURCES ARE NOT MAINS DIMMABLE
Connect up the 0-10V control cable to the mini XLR sockets on the rear of the light
source. The recommended plug for these sockets is the Multicomp SVP556-TA. The
pin out details for these plugs are shown below.