english
english
EN-42
EN-43
Operating the unit
Operating the unit
C
C
The measurements should be performed while seated. In special
cases, measurements in a lying position are also possible.
8. Body posture when taking measurements
The results for measurements taken in a sitting and lying position
may differ slightly.
Sit at a dining table, lean your back against
the backrest of the chair and bend your arm
so that your arm is exactly at heart level.
Place your feet on the ground and do not
cross your legs.
Lay on your back, place the device on your
wrist and at the height of your heart, e.g. by
supporting it with a pillow. To relax before
the measurement, take 2-3 deep breaths.
• Do not bend your wrist.
• Keep your hand relaxed, not tightened, do not make a fist.
• It is important to keep your arm calm and not to speak during
the measurement.
If the cuff is in a higher or lower position than the heart, the
measured value might be higher or lower, respectively.
Measurement while sitting
Measurement while lying down
Please pay attention to the following:
• Switch on the unit by pressing the Start/Stop
button. The full display appears (Figure 1).
• The cuff is inflated to the required pressure. The
symbol flashes in the display (Figure 2).
• The actual measurement process
starts with three beeps as the cuff
is deflated. The symbol flashes
in the display (Figure 3).
9. Measuring blood pressure
Figure 1
• A long beep denotes the end of
measurement. The cuff is auto-
matically deflated.
• The determined values of systole,
diastole and pulse and the pulse
pressure (PP) are shown alternate-
ly in the display (Figure 4, Figure 5).
Figure 4
Figure 5
Figure 2
Figure 3
• The device switches itself off after
approximately 3 minutes. You can
also switch the device off before this by pressing the Start/
Stop button.
10. Classification of the measured values (WHO)
• Upper dot (Red) signifies high pressure*
• Middle dot (Yellow) signifies borderline value*
• Lower dot (Green) signifies normal value
© Copyright Gebrauchs.info
