GETTING STARTED
Here’s what you need to get started:
- 1 or 2 x DDR4 SO-DIMM Memory
- 1 x UDOO BOLT Power Supply* or other 19VDC (min 60W power) PSUs cer
-
tified for your country (Make sure that the power cable is less than 3 mt. long)
- 1 x Bootable USB Drive with OS installation on it**;
- 1 x Monitor with HDMI or USB-C cable;
- 1 x Keyboard and Mouse.
* The UDOO BOLT Power Supply is purchased seperately.
RAM INSTALLATION
The UDOO BOLT has two 260-pin SO-DIMM sockets for DDR4 memory.
- Supports 4GB, 8GB and 16GB DDR4 SO-DIMMs up to 32GB.
- Supports 1.2V DDR4-2400 DIMMs with dual channel architecture.
In order to exploit the Dual-Channel mode make sure that you install memory
modules of the same type and density in different channel DIMM slots.
Follow these steps to install the DIMM:
- 1: Pull both clips on either side of the slot outwards. Align the DIMM modu
-
le with the slot.
- 2: Press the module straight down until the plastic clips tick and close. En
-
sure that the module fits tightly into the DIMM slot. Push the clips inwards to
check.
** This product comes without OS installed. To install it fol
-
low the get started you’ll find in UDOO website:
http://www.
udoo.org/get-started-bolt/
