Udirc U42W, Руководство пользователя, Страница: 9 / 24

9
7. Pre-flight Operation Instruction
7.1 Frequency Pairing
(1). Turn on the transmitter switch (Picture 4) and the power indicator light flashes
rapidly. Push the Left Stick all the way down to the lowest position and then
release. The Left Stick will back to the middle position automatically.
(Picture 5 / 6) The power indicator light flashes slowly, which indicates the
transmitter is ready for frequency pairing.
(2). Install the battery to the mounted box in the drone and then power on the drone.
(3). Put the drone on the flat surface, the drone body lights turn from flashing to
solid bright, which indicates successful frequency pairing.
Attaching your Mobile Phone to Transmitter
Battery installation: Open the battery cover on the back side of the transmitter and
put 4 alkaline batteries (AA, not included) into the box in accordance with
electrode instructions, as Picture shown.
Battery Cover
4X1.5V
Alkaline Batteries
Drive the screw according to the arrow
direction to loosen the screw to open
the battery cover. Tighten the screw by
driving it in opposite direction.
(1). Press the self-locking switch on the top right side of the mobile holder and
push the holder to a fully open position as Picture 1 shown.
(2). Place the mobile phone facing frontward position, pull the mobile phone holder
down and press tightly as possible to secure the mobile phone and transmitter
(please note that do not touch the mobile phone button) as Picture 2.
(3). Insert the lens hood into the slot and make sure the lower edge of the lens
hood is as close to the mobile phone as possible as Picture 3.
Picture 1 Picture 2 Picture 3
1. Make sure the electrodes are correct. 2. Do not mixed use new and old batteries.
3. Do not mixed use different kinds of batteries. 4. Do not charge the non rechargeable battery.
Notice: