MR-400/M
1
2
3
4
Alojamiento baterias
Sensor IR
On / Off
Display LCD
3
2
4
1
We recommend checking the battery level of the MH-403 microphone before
of its use, consulting the display of the MH-403 microphone itself.
610 567A
.
Rev.1
3 / 3
Preliminary
- Screw in the two antennas on the rear panel and place them in a vertical position for a better reception of the
signal.
- Connect the included power supply to the MR-400 receiver.
- Connect the audio cable to the output on the rear panel. XLR (balanced) or 6.35mm Jack.
Frequency synchronization
- Turn on the wireless microphone MH-403.
- With the receiver on, press the
button two times in a row.
The channel indicator on the display of the MR-400 receiver
will blink.
- Select the frequency (channel) using the buttons
and
. Once the selection is made, press
. The channel
will be memorized and will be shown in a fixed form.
- With the wireless microphone about 10-15cm from the receiver, press the
button on the receiver to start the
synchronization. During this process
will be shown on the MR-400 display.
- The pairing process will end when the same frequency appears on the MH-403 microphone display.
- To automatically search for a free or low interference channel, press the
button, the receiver will scan of channels
and will stop at a free one. While searching,
will be displayed on the screen.
SET
UP
DOWN
SET
SET
SYNC
ACT
SCAN
The MH-403 handheld microphone incorporates an automatic mute function, whereby the microphone activates the
mute automatically at the moment it detects lack of movement.
To activate the automatic mute of the handheld microphone, press and hold for approximately 10 seconds after turn off
until the legend
and the symbol
appears.
To deactivate the automatic mute mode of the handheld microphone, press and hold for approximately 10 seconds after
turning off until the legend
and symbol
appears.
When the word
appears at the bottom left of the display of the MH-403 microphone, the automatic mute remains
activated.
When no word appears at the bottom left of the hand mic display, the mute function auto remains disabled.
ON
OFF
AUTO
To adjust the microphone gain, press the
and
buttons on the MR-400 receiver.
UP
DOWN
Microphone gain adjustment
Auto mute