MR-400/M
1
2
3
4
Alojamiento baterias
Sensor IR
On / Off
Display LCD
3
2
4
1
Operating mode
Connect the power supply to the MR-400 receiver.
Connect the audio cable to the XLR (balanced)
or 6.35mm jack (unbalanced) output for
connect it to an amplifier or power amplifier.
Thread the two antennas on the rear panel and
place them on vertical position for better signal reception.
Press SET in the receiver until it the channel blinks in
the display.
Select the frequency with the buttons and located in the front pannel
With the wireless microphone about 10-15cm from the receiver
press the ACT button to start synchronization.
The synchronization process will end once it appears
the same frequency on the microphone display
To adjust the microphone gain, press SET and
select the Audio Gain parameter and increase or
decrease using the buttons and
We recommend checking the microphone batteries level before use
610 567A
.
Rev.0
3 / 3
