BLE RS-485 Serial Adapter
user manual V1.1
- 7 -
7.2 AT command: Please refer to page 5 section 6.
Set “role=c” or “ROLE=C” in one adapter.
The central will link with the neighboring peripheral automatically. The blue LED will
be solid on. The central will link with the paired peripheral on next time when power on.
Please reset to the default and follow the above procedures if you want to link with
other BLE devices.
7.3 APP setup: Please contact the supplier to for the test APP.
The APP will search the BLE and select one as the central.
Then select the other one as the peripheral and link.
The central will link with the neighboring peripheral automatically. The blue LED will
be solid on. The central will link with the paired peripheral on next time when power on.
Please reset to the default and follow the above procedures if you want to link with
other BLE devices.
8. APP:
The APP is used for the configuration and the data transmission test.
Scan and select one. Connect and configure Data transmission test.
Disconnect
TX area
RX area
Data mode
Clear data
and log
Device list
Select one
Scan BLE
Enable
Central
Setup
Reset
Default
Setup mode
Serial Port setting: Baud rate, Data
bit, Stop bit, Parity, flow control.
