AeroCut Velocity OPERATION MANUAL
36
②
In case the length of leading edge is wrong:
With cut mark
Input the difference between inputted value and actual
measurement into E.
EX:
In case input value is 0.400” and cut measurement is
0.450”, input -0.050 to E.
（
You can input
±
0.400” at the most
）
Without cut mark
Input the difference between inputted value and actual
measurement into F.
F
E
EX:
In case input value is 0.600” and cut measurement is
0.550”, input +0.050 to F.
（
You can input
±
0.400” at the most
）
③
In case creasing position is incorrect
J
Input the difference between inputted value and actual
creasing position into J.
EX:
In case input value is 2.000” and the actual creasing
position is 1.900” length, input +0.100 to J.
（
You can input
±
0.400” at the most
）
④
Others
In case you amend the value according to expansion
or contraction of printing.
Input magnification into L if the printing is stretching
to the feed direction.
M
L
Input magnification into M if the printing is stretching
to the width direction.
Please note that changing magnifications results in
changing actual measurements of outputs.
EX:
If printing should be 4.000” width, but actual
printing is 4.080”, input 0.980 (4.00/4.08) into L.
（
”L” must be from 0.500 times to 2.000 times and “M” must be from0.800 times to
1.200times
）
