UBTECH CADEBOT USER MANUAL
3
ǃ
First, move the machine to the location you need to mark, scan the destination
face-forward, adjust the robot tray orientation, click Add, enter the destination name (such
as table number), and confirm. The point will be automatically generated on the map.
Users can add multiple destinations. Tapping on it allows you to edit the name.
4
ǃ
Move the machine to the charging station location, click the charging station button,
click Add, face the charging station forward with the machine, and ensure that it is within
0.8m to 1m of the charging station. Confirm that there are no errors and it will
automatically generate the point on the map. If you need to rename or delete it, you can
use the corresponding keys below.
5
ǃ
Setting recycle points, meal serving points, and welcome points is similar to setting
destinations.
7
ǃ
After building the map, save it with a name and choose to upload it to the cloud or not.
Emergency Stop
In case of emergency situations such as when the robot is operating abnormally or
experiencing unexpected events that may cause harm to the surrounding environment,
users can stop the robot by pressing the top emergency stop switch. After the robot stops
moving, the chassis drive wheel unlocks and the machine can be pushed.
Note: After taking a picture at the slope while pressing the emergency stop button, please
hold the robot steady in time to prevent the chassis drive wheel from unlocking and sliding
down the slope.
Power Switch
When the machine is not in use or undergoing maintenance, please turn off the power
switch located on the side of the front directional wheel of the chassis to disconnect the
entire machine circuit. When using it again, please turn on the power switch first. After
successful switching on, the chassis light will flash to indicate that the machine is ready to
be operated normally.
