ZED-F9R - Application note
UBX-22035176 - R01
Contents
Page 9 of 30
C1-Public
2.4
Modifying the receiver configuration in UBX-CFG-VALSET
view
Figure 3 shows the UBX-CFG-VALSET message view.
1.
Select the configuration items from the
Group
and
Key Name
dropdown menus and add these to
the list of configuration items to set by clicking the
Add to list
button.
2.
To set the value to apply, select an item from the list and set the value in the
Value field
.
To poll the current value of the item, click the
Get current value
button.
3.
Select the correct memory layer(s) in the
Set value in layers
field.
4.
Click the
Send
button in the bottom left corner of the window.
Figure 3: UBX-CFG-VALSET message
During the evaluation phase, it is most simple to write the configuration directly to flash. During
development and series production, it is recommended to write the configuration to the RAM or BBR
layer at startup. The host should not write to flash at every startup because of the maximum limit on
the number flash write cycles.
2.5
Modifying the receiver configuration in the Generation 9
Advanced Configuration view
Figure 4 shows the
Generation 9 Advanced Configuration View
. This view presents all the available
configuration items as a grouped list.
1.
Add items to the list to be applied by selecting an item from the grouped list.
2.
Write the correct value in the
Value
field.
3.
Click the
Set in RAM/BBR/Flash button.
4.
To send the configuration to the receiver, click the
Send config changes
button.
