EVK-R2 - User Guide
UBX-16016088 - R10
Appendix
Page 18 of 27
B
Setting up cellular packet data connection on
PC
This section describes how to set up a packet data connection with the Windows 7 operating systems
(for PC) and EVK-R2, using the TCP/IP stack of the PC (external TCP/IP stack).
The following examples describe how to install and configure two different kinds of modem on
Windows:
1.
Low data rate modem, over the UART interface of the cellular module connected to the Windows
PC by the Cellular USB connector (J501 on EVB) or the Cellular RS232 connector (J500 on EVB)
2.
High data rate modem, over the native USB interface of the cellular module connected to the
Windows PC by the Cellular Native USB connector on the ADP
B.1
How to install and configure a low data rate modem
connection
This example describes how to install and configure a low data rate packet data connection on a PC
with the Windows 7 operating system. This uses the TCP/IP stack of the PC over the UART interface
of the cellular module connected to the Windows PC by the Cellular USB connector (J501 on EVB) or
the Cellular RS232 connector (J500 on EVB).
1.
Follow the board setup instructions in section
to provide the required connections with
EVK-R2.
2.
Select “Control panel > Phones and Modem > Modems
> Add”. This opens the Install New Modem Wizard.
3.
Select the Don’t detect my modem checkbox.
4.
Select the Standard Modem (33,600 bit/s).
