EVK-NINA-W1/EVK-NINA-B2 - User guide
UBX-17011007 - R08
Setting up the evaluation board
Page 15 of 27
C1-Public
•
EVK-NINA-B222
•
EVK-NINA-W131
•
EVK-NINA-W132
•
EVK-NINA-W151
•
EVK-NINA-W152
•
EVK-NINA-W156
2.2.1
Starting up
Perform the following steps to enable communication with the module:
1.
Start the u-blox s-center evaluation software.
2.
Use the default baud rate 115200, 8N1 with flow control. Now, it is possible to communicate with
the module through AT commands.
For a list of available AT commands, see the u-blox Short Range AT Commands Manual [5].
2.2.2
Getting the latest software
Go to the u-blox support web page to obtain the latest available software. Instructions on reflashing
the evaluation board can be found in the Software section of the NINA-B2 System Integration Manual
[8] or the NINA-W1 System Integration Manual [7].
Содержание EVK-NINA-W1
