Hardware Installation
The UniFi AP-PRO can be mounted to the wall or ceiling.
Perform the steps for the appropriate installation:
Wall Mount
1. Position the
Mounting Bracket
at the desired location on
the wall with the cable feed slot pointed towards the floor.
2. Use a pencil to mark the three holes on the wall. Use a
6
mm (
¼
") drill bit to drill the holes.
Top
Optional 25 mm (1 in) Hole for
Ethernet Cable Feed through Wall
3. Follow the instruction for your Ethernet cable feed:
-
Feeds Through the Wall
Cut or drill a circle
approximately 25 mm (1 in) in diameter, just below
the bottom center of the
Mounting Bracket
(as shown
above). Then feed the CAT5/6 cable through the hole.
-
Feeds Along the Mounting Surface
Remove the
Cable Feed Plug
on the side of the UniFi AP-PRO.
*640-00042-03*
640-00042-03