Ubiquiti ERLite-3, Руководство пользователя

Страница: 44 / 58

41
Appendix A: Command Line Interface EdgeRouter ™ Lite User Guide
Ubiquiti Networks, Inc.
Configuration Mode
To switch to configuration mode, use the configure
command.



For the show , set , and delete commands, you can press the
? key for help.
• set ? View the available commands.
• show ? View the settings that you have configured.
(Because configurations vary, the list you see will differ
from the sample list displayed below.)
• delete ? View the settings that you can delete.
Enter show and press the ? key.

    

To display the available command completions, press the
tab key.
Note: The tab does not display onscreen.


 
 
 
 
 
The EdgeRouter uses three configurations:
• Working When you make changes to the working
configuration, they are not applied until you commit the
changes to the active configuration.
• Active When you commit changes to the active
configuration, they are applied; however, the changes
do not become part of the boot configuration until you
save the changes to the boot configuration.
• Boot When the EdgeRouter reboots, it loads the boot
configuration for use.
The following scenarios cover some of the most
commonly used commands:
• Configure an Interface (see below)
• “Remove the Default User Account” on page 42
• “Create a Firewall Rule” on page 42
• “Manage the Configuration File” on page 45
Configure an Interface
To configure an interface, do the following:
• Assign an IP address and subnet mask
• Enter a description
Use the set , compare , commit , and save commands.
To configure an interface, use the set command.


To view the possible completions for the eth0 address,
enter
set interfaces ethernet eth0 address and press the
? key.


 
 


 







These changes affect the working configuration, not the
active configuration. To see what changes have been
made to the working configuration, use the
compare
command:





To make the changes active, use the commit command:


If you reboot the EdgeRouter, the changes will be lost. To
save these changes, use the
save command to save the
active configuration to the boot configuration.










   
   
   
  
  
 
 








