Ubiquiti EdgePoint R8, Быстрый старт

Страница: 4 / 36

Hardware Overview
Bottom Panel Button
Reset
Button Description
Reset
There are two methods to reset the EP-R8 to
factory defaults:
Runtime Reset (Recommended)
The EP-R8 should be running after bootup is
complete. Press and hold the Reset button
for about 10 seconds until the eth7 or SFP 2
LED starts flashing and then becomes solidly
lit (the SFP 2 LED is used if there is an SFP
module connected to the SFP 2 port). After
a few seconds, the LED will turn off, and the
EP-R8 will automatically reboot.
Power-on Reset
1. Disconnect power from the EP-R8.
2. Press and hold the Reset button while
connecting power to the EP-R8. Keep
holding the button until the eth7 or SFP 2
LED starts flashing and then stops flashing
after a few seconds (the SFP 2 LED is used
if there is an SFP module connected to the
SFP 2 port).
2
EdgePoint EP-R8 Quick Start Guide