3
OPERATION
OPERATION WITH THE CONTROL PANEL
After reading all the instructions, make sure that all the
fireplace controls are in the OFF position.
The controls are located at the front lower side of your fireplace.
:
Press this button to turn ON the fireplace.
The unit will beep. Press again to turn off the fireplace
and the fan will continue to work for 5 seconds
without heat.
:
Press this button once for the flame effect.
The unit will beep. Press again to increase the flame
again to stop the flame effect.
intensity. There are six light intensities to choose
from. The flame optics will go higher under the
sequence of 1, 2, 3, 4, 5, and 6. Press the button
:
function.
Press this button for low heat level. The indicator
light will be ON. The fireplace will provide low heat
level. Pressing once again to stop the low heat level
:
Press this button for high heat level. The unit will
beep. The fireplace will provide high heat level.
Press once again to stop the high heat level
function.
Plug the fireplace into a 15 A/120 V outlet.
OPERATION WITH THE REMOTE CONTROL
MAINTENANCE
WARNING: DISCONNECT POWER AND UNPLUG THE POWER CORD
BEFORE ATTEMPTINGANY MAINTENANCE OR CLEANING TO
REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURIES TO
PERSONS.
CLEANING
To clean the unit, first turn off the controls on the unit and
REMOTE CONTROL BATTERY REPLACEMENT
Replace with a CR2025 battery and follow the diagram at
the back of the remote handset to install the new battery.
unplug the unit from the power source. To clean the glass display
panel, remove dust with a clean dry cloth. Remove finger-prints
and other marks clean glass with clean damp cloth. Do not
use abrasive cleaners or spray liquids on the glass display panel
surface. Metal and metal-painted parts should be cleaned
with a damp cloth. Do not use abrasive cleaners or spray
liquids on these surfaces.
750 W:
function.
:
:
750W
1500W
Press this button to turn ON the fireplace.
The unit will beep. Press again to turn off
the fireplace and the fan will continue to
work for 5 seconds without heat.
The fireplace is preset to start with high heat
(1500 W) and the highest flame intensity.
Press this button once for the flame effect.
The unit will beep. Press again to increase
the flame intensity. There are six light intensities
to choose from. The flame optics will go higher under
the sequence of 1, 2, 3, 4, 5, and 6. Press the button
again to stop the flame effect.
Press this button for low heat level. The indicator
light will be ON. The fireplace will provide low heat
level. Press once again to stop the low heat level
1500 W :
Press this button for high heat level. The unit will
beep. The fireplace will provide high heat level.
Press once again to stop the high heat level
function.
Step 4: Place the crystal stone onto the bed(see Fig. D).
Fig. D
Step 5: Replace the front cover and secure it with the two
mounting screws(see Fig. E).
Fig. E
Manufactured by:
NO.169,KAN BEI ROAD,201412
www.hzflametec.com
Made in China
SHANGHAI HUANGZHOU INDUSTRY CO.,LTD
SHANGHAI,CHINA
1-844-455-4621