Uberhaus MWK-15CRN1-BK2, Руководство оператора

Страница: 12 / 25

Installation Instructions
Window Mounting
1
Remove Chassis
1. Pull down front grille and remove filter.
(See Fig.1).
2. Lift front grille upwards and place to one side.
3. Locate the four front screws and remove.
These screws will be needed to re-install
the front panel (see Fig.2).
7. Remove shipping screws from top of unit and
also on the side by the base if installed
(see Fig.6).
8. Hold the cabinet while pulling on the base pan
handle, and carefully remove the unit.
9. Add two foam inserts to holes in top of cabinet
where shipping screws were removed from
(see Fig.7).
4. Push metal cabinet side to release plastic tabs
on each side of front panel (see Fig.3).
5. Gently lift front panel off unit(see Fig.4 ).
6. Disconnect the connector plug of the display
panel from the unit and place front panel to one
side(see Fig.5).
2 Install Top Angle and
Side Bracket
1. Attach foam gasket to top angle
above holes as shown in Fig.7.
2. Install top angle and side retainers
to cabinet as shown in Fig.8 (10 screws).
3 Assemble Window Filler Panels
1. Place cabinet on floor, a bench, or
a table.
2. Slide I section of window filler panel
into side retainer on the side of the
cabinet (see Fig.9 & Fig.10).
Repeat on the other side.
,,
,,
Plastic
Frame
Window Filler
Panel
Side Retainer
Fig.9
5 1
6 l
ong
hex-h
ead
/
Front Grille
Fig.1 Fig.2
Fig.3
Fig.4
Front Panel
Fig.5
shipping
screws
Fig.6 Fig.7
Fig.8
11