3.
When the room reaches the desired temperature, turn the thermostat knob
counter-clockwise very slowly and carefully until you hear a “click.” This will
automatically set your unit to cycle on and off at that desired heat setting.
Note: It will
normally require approximately 15 minutes to reach operating temperature.
4.
If you want to change the temperature, turn thermostat clockwise to raise the temperature,
or counter-clockwise to lower.
5.
To completely shut unit off, the POWER SWITCH must be placed in
(OFF) position.
6. Your heater is equipped with an overheat protection system that shuts the unit off if it
overheats due to abnormal conditions. At this time, the CAUTION LIGHT comes on. If
this occurs, turn the heater off
(OFF) and unplug it. Then, inspect and remove any
objects on or adjacent to the heater. Allow it to cool for a few minutes, plug it back in, and
resume normal operation.
CARE AND CLEANING
Always remove the plug from the power socket and allow heater to cool. Wipe heater
with a soft damp cloth. Do not use detergents and abrasives.
Should the heater be left unused over a certain length of time, wind the cable round the
holder, and store it in a dry place.
This heater was produced according to ETL specifications and should provide you with
5
OPERATING INSTRUCTIONS
1.
Insert the plug into a properly polarized 120 V AC outlet in perfect working condition.
2.
Press POWER SWITCH to “
o
”(ON). Turn thermostat clockwise to the position.
