ubbink UWA-2E, Правила установки

Страница: 24 / 61

7 Starting appliance
7.1 Switching appliance on and off
Switching on:
▪
Switching on the mains power:
1. Connect the 230 V power plug to the electric system.
2. During the startup of the appliance, the version of the software is displayed.
If the appliance has been without power for a long time (more than approx. 1
week), you will have to reset the correct language, time and date in setting
menu .
3. The appliance will then operate immediately after this according to the mode
of the multiple switch. If no multiple switch is connected then the appliance
operates always in mode 1.
Switching off:
▪
Switching off mains power:
1. Pull the 230 V power plug from the electric system; the appliance is now free
of voltage.
2. Nothing is now shown on the display.
Warning!
When working on the appliance, always first take the voltage from the appliance by
pulling the power plug.
7.2 Setting the air flow
Good ventilation contributes to healthy air in the home, optimal comfort and the proper functioning of the
installation.
The air flows of the appliance have been set in the factory as follows 50, 100, 150 and 250 m
3
/h. The performance
and the energy consumption of the appliance depend on the pressure drop in the duct system, as well as on the
filter resistance. If these conditions are not complied with, the air flow rate of the higher mode will automatically
be adjusted.
Changes can be carried out in the settings menu .
Go in the settings menu to steps 1.2 to 1.4 to adjust the air flow.
Please note!
The highest demanded ventilation mode has priority. If the external multiple switch is set to mode 3, then the
ventilation mode cannot be adjusted to a lower mode on the main screen.
An exception to this is ventilator mode 0. If mode 0 is chosen on the display: control from other switches,
sensors, etc. is not possible.
Ubiflux Vigor W325 615743-G