UAV-1002513-001
16
Rev A
8.6.1 Altitude Encoder Correspondence Test
•
Ensure transponder is turned OFF
•
Set the primary flight altimeter to 29.92 inches of mercury
•
Turn on the tailBeacon
•
Open the “uAvionix skyBeacon Installer” as detailed in
tailBeacon
TSO User and Installation Guide
Section 10
•
Connect to tailBeacon
•
Select the Monitor screen
•
View the reported Pressure Altitude and ensure correspondence
±125 feet of the Primary Flight Altimeter
9 Post-Installation Test Procedures
Procedures that must be completed when the tailBeacon is removed and
re-installed or replaced with a new unit are detailed in this section.
Refer to
tailBeacon TSO User and Installation Guide
Section 10.3 for Post-
Installation Checks.
If no other service is to be performed, continue to the return-to-service
procedure in Section 10.
10 Troubleshooting
This section provides troubleshooting information to assist if problems
occur after maintenance activities.
Table 10-1 Troubleshooting Actions
Problem / Indication Cause
Action
Unable to see Beacon-
XXXX Wi-Fi network
•
Device not receiving
power
•
Ensure circuit breaker is
closed, navigation light
switch is on and wiring is
correct
