UAV-1003947-001, AV-30-C, Installation Manual 32
Revision C
Rotating the knob left and right will access the various parameters that
may be configured. Pressing the knob when the desired field is shown
will allow the associated setting to be adjusted. After adjustment,
pressing the knob again will disable the editing mode but the Install
Menu will remain active.
Pressing DONE will exit the Setup Menu.
Figure 16 - Setup Done / Exit Option
10.4 Install Menu Settings
The Install Menu options and settings must be configured during the
installation procedure:
Setting
Description
Options or Range
Unit Function
Unit Functionality
Set to default mode: AI or DG
Function Lock
Functionality Locked
If locked, pilot may not toggle function
with knob press
Pitch Trim
Pitch Trim
Trim as needed: ±20 Degrees
Roll Trim
Roll Trim
Trim as needed: ±5 Degrees
Slip Trim
Slip Trim
Trim as needed: ±5 Degrees
OAT Trim
OAT Probe Trim
Trim as needed: ±200 (Unitless)
IAS Trim
IAS Trim
Trim as needed: ±50 (KTS or MPH)
ALT Trim
Baro Altitude Trim
Trim as needed: ±500 Feet
IAS Units
IAS Display Units
Set to match airspeed: KTS, MPH
VSpeed Limits
Vso,Vs1,Vfe,Vno,Vne Set to match limits: 40 to 300 kts
Baro Units
Baro Setting Units
Set to match altimeter: HG, MB
Temp Units
OAT Units
Set as desired: C, F
GPS Nav Source
Serial Input
Se to match GPS type: NONE, AV1
9600, NMEA1 4800, NMEA1 9600,
BEACON X
Serial 2
Aux Serial Input
Set to NONE
Demo Mode
Demo Mode
Set to DISABLED
Software Version
Software Version
For Reference
Software Checksum Software Checksum
For Reference
Table 7 – Install Menu Options
