To put the Ganymede MEMS speaker inside of the speaker
box, first, unscrew and separate the PCB from the shell.
Remove the housing gasket and place the Ganymede MEMS
speaker with the contact side up.
Place the housing gasket and the PCB on the shell, matching
the orientation marks available on the speakers and on the
PCB. For proper sealing, ensure that the screws are correctly
tightened.
Make sure that the green wire (connected to the + pad in
Carme 3.0) must be connected to the upper pin on the Helike
board as seen in the photo above.
Carme 3.0 can be connected to both headers (MEMS L or
MEMS R) as seen in the picture on the right.
The correct placement of the Ganymede MEMS speaker is
illustrated on the following page.
SETTING UP THE SYSTEM
The speaker box Carme 3.0 is an accessory of the development board Helike UA-E3010.
Should you require assistance or further information, please contact [email protected].