![U.S. Stove Defender II Скачать руководство пользователя страница 15](http://html.mh-extra.com/html/u-s-stove/defender-ii/defender-ii_owners-manual_832232015.webp)
-15-
GLASS
•
Inspect and clean the glass regularly in order to detect any cracks. If you spot one, turn the stove off
immediately. Do not abuse the glass door by striking or slamming shut. Do not use the stove if the glass is
broken.
•
If the glass on your stove breaks, replace only with the glass supplied from your heater dealer. Never
substitute other materials for the glass.
•
To replace the glass, remove the screws retaining the glass mouldings inside the door. Remove the
mouldings and replace the damaged piece with a new one. Perform the procedure backwards after
replacing. When replacing the glass, you should change the glass gasket to make sure you keep it sealed.
•
Never wash the glass with a product that may scratch. Use a specialized product, available in the stores
where wood stoves are sold. The glass should be washed only when cold.
GASKETING
It is recommended that you change the door gasket (which makes your stove door air tight) once a year, in order to
insure good control over the combustion, maximum efficiency and security. To change the door gasket, simply remove the
damaged one. Carefully clean the available gasket groove, apply a high temperature silicone sold for this purpose, and
install the new gasket. You may light up your stove again approximately 24 hours after having completed this operation. This
unit’s door uses a 1” diameter rope gasket.
PAINT
Only clean your stove with a dry soft cloth that will not harm the paint finish. If the paint becomes scratched or damaged,
it is possible to give your wood stove a brand new look, by repainting it with a 1200° F heat resistant paint. For this purpose,
simply scrub the surface to be repainted with fine sand paper, clean it properly, and apply thin coats (2) of paint successively.
AIR TUBES
The air tubes assembled in this unit are designed to provide an accurate mix of secondary air to insure the highest efficiency.
Any damage or deterioration of these tubes may reduce the efficiency of combustion. The air tubes are held in position by
either screws or snap pins. Locate these to either side of the tube and remove to allow the tube to be removed and replaced.
WARNING: Never operate the stove without a gasket or with a broken one. Damage to the stove or even
house fire may result.
WHITE /
BLANC
GREEN /
VERT
WHITE /
BLANC
BLACK /
NOIR
BLACK /
NOIR
BLACK /
NOIR
BLOWER
RHEOSTAT /
RHÉOSTAT DU
VENTILATEUR
BLOWER MOTOR
BLOWER SPECS: 120VAC, 60 Hz AC,0.55amp
/
MTEUR DU
VENTILATEUR
DÉTAILS TECHNIQUES: 120VAC, 60 Hz CA,0,55AMP
BLACK /
NOIR
BLACK /
NOIR
Optional B36 Blower Wiring Diagram
NOTICE: DO NOT ALLOW THE POWER
CORD TO TOUCH HOT SURFACES! KEEP
THE POWER CORD AT LEAST 12”/30.5CM
FROM THE STOVE OR PIPE SURFACES.
DANGER: SHOCK HAZARD DISCONNECT
POWER SOURCE BEFORE INSTALLATION AND
WHENEVER SERVICING BLOWER ASSEMBLY.
CAUTION: MOVING PARTS CAN CAUSE
INJURY. DO NOT OPERATE WITH COVER
REMOVED.
NOTICE: ANY REPLACEMENT WIRING
MUST HAVE EQUIVALENT INSULATION
AND TEMPERATURE RATING (105° C).
Содержание Defender II
Страница 18: ... 18 Notes ...
Страница 19: ... 19 Notes ...