grip the label paper end into the groove on the Rewinder Shaft and
fix the end with the U Pin. Make sure the paper is fairly straight.
(See the attached picture.)
5. Gently adjust the position of the white rubber on the Label Guide
rod. Note that it is important to exercise care on this step; too much
force may cause the label to tear.
6. Point the sensor towards the desired label stop position. You can
either pivot the sensor on the shaft, or rotate the metal bracket, or
both.
7. Turn the Power Switch to “On”.
8. Adjust the Speed and Length Knobs until the desired settings of the
label feed are achieved.
