4
KNOW YOUR MACHINE
VACUUM LID
- This lid provides access into your recovery tank so that you can clean the tank. The lid must
be closed before you try to clean..
SOLUTION TANK FILL HOLE
- This is where you fill the tank with water and cleaning solution.
VACUUM HOSE BARB
- This is where you connect your vacuum hose to the machine. A tight connection is
necessary to prevent a vacuum leak which would reduce the amount of suction.
DRAIN HOSE
- This is how you empty the dirty water from your recovery tank. Place the hose over a drain,
and open the cap. When cleaning out the tank at the end of a job, simply place this hose into a drain and use
clean water to rinse out the dirt and debris from the tank.
NOTE
: be sure to close the cap tightly before using
the machine again.
HANDLES
- The handles are used to move the machine. These handles allow you to tilt the machine back
onto it’s 12” wheels for easy maneuvering, and/or for moving on stairways.
DRAIN
HOSE
HANDLES
VACUUM
HOSE BARB
FAN
POWER CORD
RECEPTICLES
VACUUM
LID
12”
WHEE
L
LATCH
SOLUTION HOSE
QUICK COUPLING
SWITCH
PLATE
CASTOR
SOLUTION
TANK FILL
HOLE
PSI
GAUGE
SWITCH PLATE
- The switches are located on the rear of the machine, out of the way of water
FAN
- Removes warm air from the component compartment.
PSI GAUGE
- indicates the pump pressure. Look at the pressure while you spray.
LATCH
- The latch holds together the tank and the base compartment.
SOLUTION HOSE QUICK COUPLING
- This is where you connect the solution line that runs from the machine
to the carpet wand or hand tool.
POWER CORD RECEPTACLES
- The receptacles are where the two power cords connect to the machine.
CASTOR
- Swivel castor provides easy maneuverability.
WHEEL
- The rear wheels are 12 inches in diameter to provide superior ease of transportation and stair climbing.
