SKU 91831 For technical questions please call 1-800-444-3353 PAGE 5
3.
Use clean, dry, regulated, compressed air at 90 PSI. Do not exceed the
recommended 90 PSI. Never use oxygen, carbon dioxide, combustible gases, or
any other bottled gas as a power source for this tool.
4.
When connecting to the air supply: Prior to each use, if an automatic oiler is
not used, add two drops of air tool oil (not included) into the Air Inlet (47) fitting of
the Impact Wrench.
5.
Always disconnect the Impact Wrench from its compressed air supply
source, and squeeze the Trigger (43) to release all compressed air in the
tool after use and before performing any maintenance or services.
6.
Industrial applications must follow OSHA requirements.
7.
WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram on page 9.
To Attach A Quick Connector:
1.
WARNING! Prior to performing any assembly and/or adjustment
procedures, make sure the air supply hose (not included) is disconnected
from the Impact Wrench.
2.
Prior to use, the Impact Wrench requires the attachment of a
Quick Connector
(not included) into its Air Inlet (47). To do so, wrap approximately 3” of pipe
thread sealer tape (not included) around the male threads of a Quick Connector.
Then, firmly tighten the Quick Connector into the Air Inlet.
(See Figure A, next page.)
To Operate The Impact Wrench:
1.
WARNING! always wear ANSI approved safety glasses, a full face
shield, and hearing protection when operating the Impact Wrench.
