11
111299-06 - 9/22
SteamMax
Knock-Down Assembly Instructions
DANGER
• Use precautions and appropriate rigging
apparatus when moving heavy objects.
• Use proper personal protective equipment (PPE)
during assembly.
4
Split Bases Assembly
See Figure 4-1 for References.
1. Remove split base assemblies,
Items 1 and 2
,
from shipping skids.
2. Move base assemblies to area where boiler is to
be installed.
A. Appliance is listed for installation on
combustible flooring and must not be
installed on carpeting.
B. Install on level floor. For basement installation
provide concrete base if floor is not level or if
water may be encountered on floor around
boiler.
C. Protect gas ignition system components
from water (dripping, spraying, etc.) during
appliance operation and service.
D. Locate boiler to avoid water damage in case
there is a leak. If boiler must be located in an
area sensitive to water damage, install drain
pan underneath boiler and pipe to a suitable
drain location. Manufacturer will not be held
responsible for water damage resulting from
this appliance or any of its components.
3. Set aside rear air dams, not shown. Air dams will
be installed after jacket attachment.
4. Set aside jacket top bracket, not shown, packed
with split left base assembly. Bracket will be
attached after split section assemblies are drawn.
NOTICE:
No gasket material is required between
the two bases.
5. Verify the (6) drip shields,
Item 3
, are in place,
and remove tape used to hold the drip shields in
place during shipment.
6. Use ¼-20 hex head bolts and nuts,
Item 4
, to join
split base assemblies together with jacket lower
bracket,
Item 5
, attached on left side.
7. Attach base legs,
Item 6
, to base assembly using
¼-20 self-threading screws,
Item 7
.
8. Place base assembly in location where boiler is to
be installed.
!
