19
OTHER COOL STUFF
OTHER COOL STUFF
Rush me the following cool U.S.
Amps Items. Enclosed is my check
or money order for the amount of
$________ dollars.
NAME__________________________
ADDRESS_______________________
CITY_________________ST_________
ZIP___________ PH_______________
Email Address___________________
Make sure the amount on your check
equals the GRAND TOTAL amount. Credit
Cards accepted via the U.S. Amps Internet
site: www.usamps.com
NEVER NEVER LAND:
U.S. Amps are input-isolated at the factory and require an input ground for proper operation.
Protect your investment. Use common
sense. Make sure the spot you choose is well-ventilated and free from dirt and moisture.
Remember, when
you bridge your amplifier, each channel "sees" one half of the load, hence at 4 ohms bridged
each channel is operating at 2 ohms, which is the minimum impedance for XTERMINATOR
models. U.S. Amps makes the USA Series of 1 ohm stable amplifiers if you wish to bridge into 2
ohms, plus an array of "high current" products that are purpose-designed to operate at even
lower impedances. FAILURE TO OBSERVE THIS BASIC RULE WILL RESULT IN A SENSELESS WASTE OF
POWER AND PERFORMANCE, and could damage your amplifier.
NEVER
NEVER
NEVER
USE A U.S. AMP WITH A GROUND LOOP ISOLATOR OR AN ISOLATED INPUT SIGNAL.
INSTALL OR MOUNT YOUR AMPLIFIER DIRECTLY TO A SPEAKER ENCLOSURE OR
ANYWHERE ELSE WHERE SEVERE VIBRATION IS PRESENT.
USE YOUR U.S. AMP BELOW THE RATED MINIMUM IMPEDANCE.
NEVER NEVER LAND:
NEVER
NEVER
NEVER
USE A U.S. AMP WITH A GROUND LOOP ISOLATOR OR AN ISOLATED INPUT SIGNAL.
INSTALL OR MOUNT YOUR AMPLIFIER DIRECTLY TO A SPEAKER ENCLOSURE OR
ANYWHERE ELSE WHERE SEVERE VIBRATION IS PRESENT.
USE YOUR U.S. AMP BELOW THE RATED MINIMUM IMPEDANCE.
ORDER FORM
ORDER FORM
