U.N.O MOTIVE FITNESS TR 100, Руководство пользователя

Страница: 12 / 24

Warning:
1) The safety level of the equipment can be maintained only if it is examined regularly for damage
and wear, e.g. pins, connection points.
2) Please replace defective components immediately and/or keep the equipment out of use until repair.
12
Malfunction Reason Treatment
1. Power on but no display on the
computer
1. Plug incorrectly.
2. Overload protection switch
is off
3. Transformer is inserted
incorrectly.
4. The fuse in the driver is
burned.
1. Plug it again.
2. Reset it.
3. check it up or replace it.
4. Replace it
2. Show Er01, Speed sensor
malfunction
1. Speed sensor is broken or
installed incorrectly.
2. Optocoupler in the driver is
damaged
3.other parts outside IC is
broken
1. Check up the install position or
replace the speed sensor
2. Replace Driver or the
Optocoupler
3. Replace driver
3. Show Er02, motor electricity
overload malfunction
1.Overload current through the
motor
2. Obstruction of the roller is
too much
3. Driver is damaged
1. replace the motor
2.enhance lubricating or
replace it
3. replace the driver
4. Show Er03, Correspond failure
1.undesirable signal wire
2. Optocoupler in the driver is
damaged
3. Computer is damaged
1.check up the signal wire’s
connector to the computer
and the driver
2. replace driver or the
Optocoupler
3. replace computer board
5. Show Er04, driver power
malfunction
1. motor haven’t inserted well
or motor’s damaged
(broken circuit)
2. the relay of the driver is
damaged
3. the bridge of the driver is
damaged
4. other parts outside IC is
damaged
1.check up or replace a
motor
2. replace driver or relay
3. replace driver or bridge
4. replace driver
6. If incline window will show “--”,
incline is in malfunction.
1. Incline motor sensor insert
incorrectly.
2. Incline motor sensor is
damaged.
3. parts in the driver is
damaged
1. check up the connection
of the plug
2. replace incline motor
3. replace driver
7. Without loading, operate normally.
With loading, hard to start and with
stops.
1. Driver’s torque regulation is
small
2.running belt gets loose
3. undesirable motor
1. adjust the torque
2. adjust running belt
3. replace motor