U-Line Wine Captain Echelon Series, Руководство по установке, Страница: 15 / 16

03/2008 15 www.U-LineService.com
2115WC/2115WCOL2 Wine Captain ®
Single Unit Installation
1. Remove the two screws from the opposite side of the
hinge assembly using a Phillips screwdriver ( Figure
30 ).
Right–handed units shown, Left–handed units are mirrored
Figure 30
2. Place bracket (part # 14154) over holes and attach to
unit with two screws removed in step 1 using a Phillips
screwdriver. Tighten screws fully.
3. Recheck the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.
4. Secure bracket into adjoining surface.
Side-by-Side Installation
1. Remove screws shown ( Figure 31 ).
CAUTION
Be sure to remove and discard screw shown. Failure
to do so may cause damage to the bracket and/or
unit.
Figure 31
2. Place bracket as shown, and re-attach screws to unit
using a Phillips screwdriver. Tighten screws fully.
3. Recheck the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.
Installation Troubleshooting
Problem
The door remains open unless it is pushed closed.
Solution
The hinges should be self-closing when the door is open
approximately 8”. If this is not the case, make sure the
closers (at the bottom of the hinge pin) are clean, greased
and installed correctly. Also, re-check leveling from front-
to-back of the unit and adjust as necessary. Make sure
that pivot plate is installed correctly.
Installation Troubleshooting
Problem
Q:
The door remains open unless it is pushed closed.
Solution
A:
The hinges should be self-closing when the door is open
approximately 8". If this is not the case, make sure the
closers (at the bottom of the hinge pin) are clean, greased
and installed correctly. Also, re-check leveling from front
to back of the unit and readjust if necessary. Make sure
that pivot plate is installed correctly.
Initial Start-Up
The unit is shipped with the control preset. No adjustments
should be necessary at this time. For information about
Adjusting the Temperature Control, see the Use and Care
Guide.
Start-Up Troubleshooting
Problem
Q:
Unit does not appear to turn on when plugged in.
Solution
A:
Make sure outlet has power (circuit breaker has not
tripped). Check to see that control is turned on.
Problem
Q:
Light is on with door closed.
1/4”
Remove and
discard screw
9 Start-Up for the First Time