PAGE 9 OF 30
0821 IH-9464
INSTALLING AND CLEANING CARTRIDGE FILTER CONTINUED
INSTALLING AND CLEANING FOAM WET FILTER
5. Place filter retainer on top of
cartridge filter over the raised
lip and tighten down by turning
retainer clockwise. Do not
overtighten. (See Figures 42-43)
REMOVING AND CLEANING
CARTRIDGE FILTER
1. Unlock and remove the filter retainer by turning
retainer handle counterclockwise.
2. Carefully hold and pull the
cartridge filter up for removal.
(See Figure 44)
3. Clean the cartridge filter by
gently tapping or brushing off
dirt. Cleaning should not be
done indoors in living areas. For
optimal performance, a new filter is
recommended.
4. Install cleaned or new filter into place as instructed
in steps 2 and 3 of Installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry
for 24 hours before installing onto the filter cage.
IMPORTANT! Clean or change the cartridge
filter regularly for best performance.
INSTALLING FOAM WET FILTER
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 45)
2. Remove power head and place
in upside down position. Follow
instructions to remove cartridge
filter.
3. Carefully slide foam wet filter
down over the filter cage,
ensuring the cage is completely
covered. (See Figures 46-47)
CLEANING FOAM WET FILTER
1. With the removed power head
in an upside down position,
carefully remove foam wet filter.
(See Figure 48)
2. Use a mild soap and water
solution to wash foam wet filter
and rinse with clean water.
(See Figure 49)
3. Allow filter to air dry before
installing and using again.
Figure 42
Figure 44
Figure 45
Figure 46
Figure 47
Figure 48
Figure 49
Figure 43
