Overlay Frame
1
Model Coverage
Overlay Preparation
Use the following instructions to create or have a wood overlay
panel created for your Wine Captain® or beverage Center.
IMPORTANT
IMPORTANT
When having the frame or overlay finished with a stain, be
sure to finish both sides. The back side of the frame /
overlay may be visible through the glass while the door is
open in some installations.
1. Determine cabinet toe kick height. Measure the difference
between the surface the appliance will sit on and the bottom of
the adjacent cabinetry. Make note of this.
2. Create a frame or overlay using the dimensions provided in the
figure below.
Note:
Dimensions will vary based on the levelness of the floor. If
floor is uneven, cut panel to the next longer dimension and adjust
level legs to achieve proper fit
3. Drill holes for pivot pins, upper door hinge and lower door
hinge as shown
1 Overlay
This guide covers the following models
U-2115WCOL-00
U-2175WCCOL-00
U-2175BEVCOL-00
U-2175WCCOL-02
U-2175BEVCOL-02
U-2175WCCOL-60
U-2175BEVCOL-60
U-2275ZWCOL-00
U-2175RCGOL-00
U-2275ZWCOL-60
9/32
See Detail C
3/4”
Detail C
Scale 2:1
Door bottom
Ø 3/8” x 1/4” deep
Chamfer 1/32” x 45°
Detail A
Scale 2:1
Door top
Ø 3/16” x 11/16” deep
9/32”
3/8”
See Detail A
Dim. B
NOTE: Front view of
wood panel with
right-hand hinge shown
(mirror image
for left-hand hinge)
Section A-A
Scale 2:1
Typ 4 places
NOTE: Final component
is only a picture frame.
No panel inside of rails.
(Excludes -60 Models)
(Excludes -60 Models)
Right-hand
isometric view
shown.
Opposite
for left-hand
A
A
Dim. A
3/4”
2-1/4”
Dimension A Table
Model
Dimension A
2275ZWCOL
2175WCCOL
2175BEVCOL
2115WCOL
23-3/4”
23-3/4”
23-3/4”
14-3/4”
(See Table)
Dimension B Table
Toe Kick
Toe Kick
Dim. B
Dim. B
3-3/4”
3-7/8”
4”
4-1/8”
4 1/4”
4-3/8”
4-1/2”
29-3/4”
29-3/4”
29-5/8”
29-1/2”
29-3/8”
29-1/4”
29-1/4”
