02/2005
5
www.U-LineService.com
BI-95 Ice Maker
Reversing the Door
All units may be left- or right-hand opening.
Note:
The grille should not yet be installed. If it has been
installed, remove it for door reversing. See
Page
10
.
To reverse the door:
1. Remove top hinge from cabinet (three screws). See
Figure 4
. Hold door to keep it from falling.
2. Lift the door off the bottom hinge.
3. Remove bottom hinge from cabinet (two screws). See
Figure 5
. Remove screws on opposite side of cabinet
(
Figure 6
). Note that there may be a nut behind one or
both screws on either side.
4. Install hinge on opposite side, bottom of cabinet. See
Figure 7
. Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
5. Relocate plastic spacer/
bushing on bottom of
door to opposite side,
and place door on
bottom hinge pin. See
Figure 8
. Clean out
bushing hole in door
bottom with a
screwdriver if necessary.
6. Remove plastic hole
plug from door handle
and relocate on
opposite side. See
Figure 9
.
7. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge. See
Figure 9
.
8. Remove three plastic
screw plugs from hinge
holes, top of cabinet,
opposite side. Be careful
not to scratch cabinet.
See
Figure 10
.
9. Place door on lower
hinge pin. Invert and
install upper hinge on
door.
Figure 4
Figure 5
Figure 6
Figure 7
Bushing
Figure 8
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
Figure 9
Figure 10
