PAGE 3 OF 12
0521 IH-9447
OPERATION CONTINUED
3. Raise table to a partially
folded position. Transfer
hands to benches about
halfway down for good
leverage. Close table to
engage retainer latch.
(See Figure 10)
ADJUSTING TABLE HEIGHT
NOTE: Table height can be adjusted to 27", 29"
or 30" high. Preset table height is 29" high.
1. Loosen and remove nut, bolt and glide washer on
upper end leg frame and pivot straps using 1/2"
wrenches. Repeat on opposite end leg.
(See Figure 11)
NOTE: Ensure table is opened to the in-use
position.
2. While supporting tabletop, raise (or lower) straps to
align holes at desired height. (See Figure 12)
3. Insert bolt and glide washer and refasten using nut
and 1/2" wrenches. Do not overtighten. Repeat on
opposite end leg. (See Figure 13)
4. Loosen and remove two bolts and nuts from center
leg frame and adjustable tubes using 1/2" wrenches.
Repeat on opposite center leg. (See Figure 14)
5. Raise (or lower) tubes to align holes at desired
height. (See Figure 15)
NOTE: Tubes may be tight and difficult to
slide. A rubber mallet can be used to carefully
loosen the tubes and allow them to slide easier.
Figure 12
Figure 14
Figure 15
30"
29"
27"
Figure 13
Holes
Figure 11
Figure 10
