PAGE 2 OF 12
0621 IH-8935
3. With another person, lift the platform until roller
pins meet the latch stops located on each side of
platform.
4. Lift latch stops. Keeping the latch stops lifted,
continue lifting the platform until it is fully raised.
(See Figure 2)
5. While keeping the platform raised, place the pin
from step 2 into the hole in the roller track closest to
the hinge. (See Figure 3)
INSTALLING ORANGE SPRING
1. On the side of the base with roller tracks, insert
the orange spring into the spring pocket. Ensure
alignment tab is inside the spring. (See Figure 4)
2. Firmly holding the spring a few coils down from the
top, compress the spring and slide it into the upper
spring pocket. Ensure the spring is fully seated in
both the upper and lower pockets.
WARNING! Do not hold the top coil of the
spring. Doing so may cause hands and fingers
to be crushed when sliding in the spring.
3. Remove the pin from its current location in the roller
track. The platform should now remain elevated.
4. Press down on platform until the two latch stops fall
back into place behind roller pins. (See Figure 5)
5. Lift damper back into place and secure with pin.
6. Secure spring with the safety lock.
INSTALLING ADDITIONAL SPRINGS
1. Additional springs can be installed through the
bayonet openings as needed. (See Figure 6)
2. Secure the bayonets by placing them into the
openings and turning clockwise. Secure the
bayonets with the safety lock.
3. For spring configurations, see the Spring Selection
chart on page 3.
INSTRUCTIONS CONTINUED
Figure 5
Figure 3
Figure 6
Figure 4
Alignment Tab
Bayonet
Safety
Lock
Figure 2
