PAGE 2 OF 6
0621 IH-8013
TROUBLESHOOTING
REPAIR
OPERATING ISSUE
RECOMMENDATIONS
Overheating light is yellow.
Discontinue use of unit until the light turns off.
Allow unit to cool for five minutes after ten minutes of continuous use.
Unit not sealing.
Discontinue use until power is above 100V.
Over Current light is red.
Move induction wand from jar and cap surface until the light turns off.
Smoking
Reduce sealing time.
START BUTTON REPLACEMENT
NOTE: Make sure unit is not connected to power.
1. Remove top of sealer wand. (See Figure 4)
2. Remove wires and start
button by unscrewing
nut. (See Figure 4)
3. Insert new start button
and secure with nut.
Reattach wires.
FUSE REPLACEMENT
1. Using screwdriver, pop
open fuse under plug.
(See Figure 5)
2. Remove old fuse and
insert new fuse.
(See Figure 6)
Figure 4
Nut
Figure 6
Figure 5
Sealer
Wand
1-800-295-5510
uline.com
