PAGE 1 OF 6
0522 IH-801
1-800-295-5510
uline.com
PAPER TAPE DISPENSER – 3"
H-801
FILLING TANK
1. Remove screws and bridge from dispenser.
(See Figure 1)
2. Remove and thoroughly wash brush in warm, soapy
water before initial use. (See Figure 2)
3. Fill tank to 1/2" from top.
NOTE: To remove tank, first remove bridge, then
lift tank off of the dispenser
4. Replace brush and close lid on tank.
5. Reattach bridge to dispenser with previously
removed screws.
LOADING TAPE
1. Unroll 15 inches of tape.
2. Adjust tape divider to width of tape. Place tape in
cradle. (See Figures 3-4)
NOTE: Unwound portion of tape should be on
bottom of roll off the back and with adhesive
side facing up.
3. Insert tape end in back of two rollers. Push tape
through the underside of the dispenser until the end
comes out in front of the tape cradle. (See Figure 5)
INSTRUCTIONS
Figure 5
Figure 1
Bridge
Figure 2
Brush
Tank
Tape Divider
Figure 3
Figure 4
Adhesive Side
of Tape
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
