PAGE 4 OF 15
0321 IH-7812
1. Place the bottom (6) in lowest notch of shelf
adjusting strips so that the flange with two holes
faces the front and is over the flange of the frame
sill. Push out on side wall to enable bottom to slide
into position. (See Figure 5)
2. Bolt bottom to frame sill.
3. Using a rubber mallet, place adjustable shelves in
desired position with channeled edge toward front
and press end and back flanges into notches of
shelf adjusting strips.
4. Set the unit upright and insert the remaining shelves
as desired. (See Figure 6)
5. Tighten all hardware.
ATTACHING HANDLE
1. Place the door handle
(9) on the right hand
door and fasten with
two slotted bolts
and lockwashers.
(See Figure 7)
2. Turn the handle to the
open position (parallel
to the ground) and
hook the locking bars
(8) to the locking
cam (10).
3. With the handle still
in the open position,
place the locking cam
(10) over the square
shank of the door
handle. The shank must
be facing downward as
shown. (See Figure 8)
4. Hold the lock bars in
position while sliding
the lock bar guides (12)
over the lock bar ends
of the bars and through
the door slots.
(See Figure 8)
5. Place the cotter pin (11)
through the hole of the
square shank of the
door handle.
(See Figure 9)
6. Place dummy handle
on left hand door and
fasten with bolts and
lock washers.
CABINET ASSEMBLY CONTINUED
6
Figure 5
Figure 6
9
10
11
12
8
8
10
Figure 7
Figure 9
Figure 8
