PAGE 2 OF 6
0521 IH-3879
ASSEMBLY CONTINUED
SPINNER BASE ASSEMBLY
1. Set spinner base top with underside facing up on a
protected surface.
2. Install camlock pins into predrilled holes of the spinner
base using screwdriver. (See Figure 1)
3. Set the kick base onto the spinner base so the
camlocks and camlock pins match up, and tighten
camlocks. (See Figure 5)
NOTE: If you do not want the spinner base to
rotate, install a screw through the bottom base
panel into the top base panel, taking care
not to puncture through the surface of the
top base panel. This will stabilize the spinner
component of the base unit.
CASTERS INSTALLATION (OPTIONAL)
1. Position the casters onto each of the four corners of
kick base assembly. (See Figure 6)
2. Using four pan head screws per caster, attach the
casters through the predrilled holes on the inside
corners of the kick base. (See Figure 6)
NOTE: Install all screws before the final tightening
to allow for easier alignment of casters.
4-WAY DISPLAY PANELS INSTALLATION
1. Flip spinner base top right side up.
2. Install four wooden dowel pins into the pre-drilled
holes on the base top. (See Figure 7)
NOTE: Two people are recommended for steps
3 through 5.
3. Install two panels onto the dowel pins so that they are
perpendicular to each other. Locate the holes on the
bottom of the panels and set them onto the dowel pins.
(See Figure 8)
4. Attach panels together by installing confirmat screws
into predrilled holes using Phillips screwdriver.
(See Figure 9)
NOTE: Do not fully tighten screws until all the
panels are in place. Once wing panels are in
place, tighten screws completely.
5. Install remaining panels in the same manner.
6. To cover the exposed screw heads, peel the
decorative screw caps to expose the sticky back,
and carefully center and cover the screw heads.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Dowel Pin
1-800-295-5510
uline.com
