PAGE 3 OF 5
0514 IH-3505
1. Remove cover from plastic bag and unfold. Next
fold half the cover over the other half with the
white side out. Match the corners (See Figure 6A)
and mark the top center of cover at the grommet
line at both ends. (See Figure 6B)
2. Once centers have been marked at both ends, pull
cover over frame with white side down. (See Figure 7)
3. Position the center mark with the top center pipe
of frame.
4. Attach cover to each end of top curved frame by
running ball strap through grommet hole, around
pipe and hook back over ball. (See Figures 8-9)
5. Once you have secured top to curved section
of frame, finish frame assembly. Assemble the
remaining frame on each side using the 21.5" pipe,
foot pads and 58" pipe. (See Figure 10) Make sure
hooks on the feet are on the inside of frame. Push in
on leg sections and make sure the legs are securely
set on ground before assembling final side and
standing canopy up. This will keep the canopy
from sliding.
6. Now that you have completed the frame assembly
and your canopy is standing, take the cables
provided and hook one end to each foot
(See Figure 11-12), over to the foot on the opposite
side. You may have to push out or pull in to get
cables hooked. Make sure cables are tight across.
These cables keep the canopy frame with the
designed curved shape.
NOTE: Be careful NOT to trip over cables.
COVER AND LEGS ASSEMBLY CONTINUED
Figure 9
Inside View
Outside View
Figure 7
Figure 10
Figure 12
Figure 11
Figure 8
Figure 6B
Figure 6A
