PAGE 2 OF 9
0221 IH-2753
ASSEMBLY INSTRUCTIONS CONTINUED
2. Align mechanism over pre-drilled holes on underside
of seat cushion with tension knob facing front of seat.
Attach mechanism to seat cushion using four
1/4
"
x 3/4
"
screws. (See Figure 2)
Note: Use Allen wrench to tightly secure all
screws.
3. Align armrest with arm holes on one side of seat and
back cushion. Insert four 1/4
"
x 1
"
screws and lightly
tighten to attach. Repeat on opposite side. Once all
eight screws are fully tightened, place plastic caps
into arm holes. (See Figure 3)
4. Slowly lower assembled chair and insert center of
mechanism into gas lift with dust cover. Press down
on seat to secure in place. (See Figure 4)
Figure 2
Figure 3
Figure 4
Front
of Seat
