PAGE 1 OF 6
0521 IH-2597
H-2597
PLASTIC WALL MOUNT
SANITARY NAPKIN
RECEPTACLE
1-800-295-5510
uline.com
TOOLS NEEDED
Drill
Drill Bit
Phillips Screwdriver
Receptacle x 1
Liner x 1
Adhesive Strip x 2
Screw x 2
Level
Tape Measure
PARTS
MOUNTING INSTRUCTIONS
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition.
Enclosed hardware may not be compatible
with wall surface.
NOTE: Recommended mounting height is
approximately equal to toilet tissue dispenser.
SCREWS
1. Hold up receptacle to desired location and mark two
holes on the wall where screws will be inserted.
(See Figure 1)
2. Drill into wall at two marked locations with
appropriate-sized drill bit. Insert wall anchors if
necessary.
3. Hold receptacle over previously drilled holes and
insert screws.
ADHESIVE STRIPS
1. Remove backing from adhesive strips.
2. Firmly press onto receptacle. (See Figure 2)
3. Remove secondary backing from strips. Press
receptacle firmly onto surface.
Figure 1
Figure 2
Mounting Locations
Recommended
Placement
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
