0810 IH-2590
PAGE 2 OF 3
1. After tape has been loaded and fed, turn power
switch off.
2. Set tape length display to required length using the
push buttons above and below the
numerical display.
NOTE: The length shown is in millimeters.
3. Flip auto/manual switch to desired location.
4. AUTO: When the cut piece of tape is removed from
the machine, the next piece is automatically fed
and cut. The interval knob will set the time delay
before the next piece is dispensed. Maximum delay
is 25 seconds.
5. MANUAL: The tape advance button must be pressed
each time a piece of tape is needed.
6. The tape will then be fed and cut.
7. Turn power switch on.
8. Press tape advance button to begin dispensing
tape.
NOTE: Tape lengths vary depending on
material. Verify length of first piece.
1. With power switch off, plug power cord into
dispenser and then into wall outlet.
2. Make sure machine is grounded properly.
3. Set the tape length display to 200mm.
4. Set the auto/manual switch to manual.
5. Turn dispenser power switch on, switch will be
illuminated.
6. Place tape roll on reel holder.
7. Put reel holder into reel holder slots.
8. Open latched top cover and remove metal hold
down shaft.
9. Press end of tape firmly onto metal feed roller, then
replace hold down shaft over tape and close top
cover.
10. Press tape advance button.
11. Remove tape then press tape advance button
again to ensure proper feeding.
SET-UP
OPERATION
SPECIFICATIONS
MODEl
#
TAPE
WIDTH
CUT
lENGTH
MAx.
OUTSIDE
DIAMETER
CORE
DIAMETER**
ACCURACY
OF CUT*
TAPE
CUTTER
FEED
TYPE
lENGTH
SETTING
WEIGHT
DIMENSIONS
TDA080
.25 to 3.15"
(6.4 to 8.0mm)
2 to 394"
(50 to 9999mm)
9"
(251mm)
3"
(76.2mm)
+/- 0.4"
(1mm)
Automatic Automatic
Digital
21lbs.
(9.5kg)
9"(L) x 6.625"(W) x 12"(H) /
229mm(L) x 168mm(W) x 305(H)
• Auxiliary stand available for diameters up to 24”.
* Dependent on material.
** Other sizes available.
