0715 IH-2268
PAGE 6 OF 7
HOW TO REPLACE BRUSH STRIPS CONTINUED
b. Replace the second strip from opposite ends of
the brush roll. Replace shaft. Align indentation
on bearing pulley retainer (F) with brush strips
and press outer tube (D) into position. Screw
bearing pulley retainer (C) into inner tube
until tight. Reassemble remainder of brush roll,
making sure it turns freely, and secure to the
base. (See Figure 22)
AIR PATH CLEANOUT
The cleaner is equipped with an air path cleanout,
located at the turn leading into the dust bag. To access,
open the dust bag cover and grasp the inlet assembly
at the air path opening. Pull up on the hinged assembly
to reveal the top of the air path. Clean out any debris
and snap the inlet assembly back into place.
(See Figure 23)
PRE-MOTOR FILTER
NOTE: Check the pre-motor filter located under
the dust bag. Check the filter each time the dust
bag is changed. Clean or replace as needed.
Shake filter to remove excess dust. If necessary,
the filter can be cleaned by vacuuming with
another cleaner or washing with mild detergent.
Reinstall filter when completely dry.
MAINTENANCE CONTINUED
Figure 23
ROUTINE MAINTENANCE
DAILY
1. Check Dust Bag – Before each use, check the
disposable dust bag and empty if three-quarters full
or more.
2. Belt Condition – Check the belt for signs of wear.
Change the belt when it is loose or has cuts or
cracks. Refer to the diagram on the underside of the
base for proper installation of belt and brushroll.
3. Supply Cord and Plug – Check supply cord and
plug for any cuts or damage. If damaged, have
the supply cord and plug assembly replaced by a
qualified Sanitaire repair center.
4. Motor – If there are unusual sounds or if poor
performance occurs, the motor should be inspected
immediately by a qualified Sanitaire repair center.
WEEKLY
1. Cloth Dust Bag – Inspect the dust bag assembly for
any unusual wear. Replace bent clips, stretched
springs or a worn bag with genuine Sanitaire
replacement parts.
2. Brushroll Bristle Strips – Check the bristles for wear
once a week. The bristle strips should be replaced
when the bristles are less than 1/4 inch in length.
3. Brush Roll Condition – Check for and remove
any loose material such as string or hair wrapped
around the brushroll.
4. Filter – Check the washable, reusable HEPA filter for
clogs and clean or rinse as needed.
MONTHLY
1. Cleaning – Inspect and clean the vacuum,
including the fan chamber and under the hood.
2. Electrical – Inspect the cord assembly for wear and
check for proper handle assembly.
3. Handle – Check the handle assembly for tightness,
and replace handle bolts if missing.
4. Motor – A qualified Sanitaire repair center should
make a routine check of the motor every 6 months.
Inspect the motor immediately if there are any
unusual sounds or if poor performance occurs.
5. Filter – Check the washable, reusable HEPA filter for
clogs and clean or rinse as needed.
